4000 HART Device DTM (Version 1.0.2 ) Installation Notes:

CONTENTS:

1. NOTE ABOUT CHANGES IN THIS VERSION OF DTM
2. GENERAL SYSTEM REQUIREMENTS
3. HOW TO INSTALL OR UPGRADE DTM
4. HOW TO UNINSTALL DTM
5. INSTALLATION TROUBLESHOOTING

------------------------------------------------------------------
1. NOTE ABOUT CHANGES IN THIS VERSION OF DTM
------------------------------------------------------------------

Please read the ChangeLog.txt document, which can be found in 
DTM program folder, for information on what changes have
been made in this release of DTM.

------------------------------------------------------------------
2. GENERAL SYSTEM REQUIREMENTS
------------------------------------------------------------------

DTMs version 1.0.2 is adhereing to FDT standard 1.2.1 and have been 
tested in the following systems and has been found to work fine. 

=====>(Typical System)

IBM PC Compatible
As required by FDT frame application and/or 
Pentium 4 or higher with at least 512MB RAM.
1 GB of Free Disk Space to install DTMs

Video with at least 256 colors.

Windows 7 (32Bit & 64Bit) 
    or
Windows 8 (32Bit & 64Bit) 
    or
Windows 10 (32Bit & 64Bit) 


Windows service packs are available from Microsoft on the website. Use 
of the latest Windows service pack and update is highly recommended.

------------------------------------------------------------------
3. HOW TO INSTALL OR UPGRADE DTM
------------------------------------------------------------------

To run DTM setup, double-click the "Setup.exe" file in your CD-ROM drive.  
Once the setup starts, simply follow the directions presented on-screen.

If a previous version of DTM software is detected during setup,
the Setup program will upgrade the software automatically.  

After installation completes, the DTM is ready to be configured through 
frame application supporting 1.2.1 FDT specifications. 

------------------------------------------------------------------
4. HOW TO UNINSTALL DTM
------------------------------------------------------------------

Use the Windows Control Panel Add/Remove Programs applet to uninstall
DTM software.

------------------------------------------------------------------
5. INSTALLATION TROUBLESHOOTING
------------------------------------------------------------------

Most DTM installations take place with no difficulties.  In the 
event this is not true for your installation, please log on to your 
computer system as the Administrator and run the setup again. 
This should remedy most installation problems, but please note the user 
name you will log in with later when using DTM must have security 
system privileges on XP systems that allow reading and writing the
Windows registry.  If necessary, please ask your system administrator
or IT department to ensure your user account has the 
required privileges. 
